Atc 250r swing arm9/20/2023 I put those on the outside to protect the needle bearings from dirt and to keep the grease In. I ordered 2 more seals, like the ones on the Inside of the pivot section of the 450r swinger. Then pressed the needle bearings towards the center of the swingarm. I took the outer dust caps off, then milled the step for the dust seal completly off. I have a 450r swingarm on my 350x with a crf450 engine. Last edited by Dirtcrasher 03-24-2008 at 08:55 PM. I'll work on it on my end.Įnough of us have parts kicken around that we need to stop guessing and waiting untill 2020 to figure out how many cheaper and available parts from other models work without compromising HONDA technology. Again, I have to look into allot better but I'm tired of dicken around, We need some better concrete information rather than "MAYBE". Possibly just a couple of spacer and we could run a 450R axle. The 450R axle sure looked with a quick measurement to be the exact same outside diameter in the bearing area as the 350X. When I get a chance, I'm gonna measure and half arse blueprint every friggin axle, carrier and swinger I have so when can see whats possible. Just don't go buying up all the 450R swingarms yet 350 s. It is basically a plate with a hole drilled in it for the swingarm bolt and it contours to the 350X frame rail where it is welded. However, if the swingarm supports in the 350X were moved outwards, it could work. I'm not sure what the width of a 250R swinger is, but it must be a bit wider than the 350X swinger - Could someone measure their 250R swinger please?Īgain, this was a quick thing but it didn't make me happy. The rough outside dimension of the 350X swinger with the dust seal caps removed was 8.375 and the 450R was 9.125. Regardless of how much you take off of the 2 sides where the dust caps sit, you would have to mill or grind all the way down into the swingarm side rails in order for it to fit in the 350X swingarm bolt area in the frame. I'm not sure who got one on there 350X, but it sure doesn't look to be a mod for the average person. So, today I took a brief look at the 450R versus a 350X swingarm.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |